PublicArchives/Sovol-SV06-firmware
1
0
Fork 0
mirror of https://github.com/bassamanator/Sovol-SV06-firmware.git synced 2025-11-08 13:31:16 +00:00
Code Issues Packages Projects Releases Wiki Activity

More clairity to configure section.

Browse Source
This commit is contained in:
Bassam Husain
2023-07-01 01:36:14 -04:00
parent d6f03f7a2c 5f59d5bacb
commit bb90be25cc
2 changed files with 33 additions and 28 deletions
Download Patch File Download Diff File Expand all files Collapse all files

13
README.md
View File

@@ -152,11 +152,14 @@ If you've done everything correctly, you should see no errors or warnings in you
You will be pasting/typing these commands into the Mainsail/Fluidd console.
1. `G28`
1. Check to see if `X` and `Y` max positions (`G90`, `G1 X223 F3000`, `G1 Y223 F3000`) can be reached, and adjust `position_max`, if necessary. You can probably go all the way up to `225` for `X` and `Y` both, however, I would not recommend it.
2. Do a `G34`; mechanical gantry calibration. After the controlled collision against the beam at the top, there will be a 10 second pause for you to verify that both sides of the gantry are pressed up against the `stoppers` at the top. You will hear a succession of beeps.
1. Figure out your `Z` `position_max` by baby stepping your way up to the beam. The range is 250 to 261 from what I've seen, could be even higher for you. Adjust `position_max`, if necessary. I can go all the way to 258, however, I would not print anything higher than 257.
3. PID tune the bed, but first move the printhead to the center. Ideally, all PID tuning should occur at the temperatures that you print most at.
1. Check to see if `X` and `Y` max positions can be reached, and adjust `position_max`, if necessary. You might be able to go further, which is great, but I recommend leaving a 2mm gap for safety.
1. `G28`
2. `G90`
3. `G1 X223 F3000`
4. `G1 Y223 F3000`
2. Do a mechanical gantry calibration; `G34`. After the controlled collision against the beam at the top, there will be a 10 second pause for you to verify that both sides of the gantry are pressed up against the `stoppers` at the top. You will hear a succession of beeps.
1. Figure out your `Z` `position_max` by baby stepping your way up to the beam, and adjust `position_max`, if necessary.
3. PID tune the bed. Ideally, all PID tuning should occur at the temperatures that you print most at.
1. `PID_TEST_BED`
2. `SAVE_CONFIG` (once completed)
4. PID tune the extruder while part cooling fan runs at 25%.