Added adxl345 settings. Added z_hop to safe_z_home. Disabled stealthchop.

klipper-printer-sovol-sv06.cfg

@@ -16,6 +16,20 @@
 serial: /dev/serial/by-id/usb-1a86_USB2.0-Serial-if00-port0
 restart_method: command
 
+
+[adxl345]
+cs_pin: rpi:None
+
+[resonance_tester]
+accel_chip: adxl345
+probe_points: 110, 110, 20
+
+# [input_shaper]
+# shaper_freq_x = 114.6
+# shaper_type_x: mzv
+# shaper_freq_y = 77
+# shaper_type_y: mzv
+
 [printer]
 kinematics: cartesian
 max_velocity: 300
@@ -38,7 +52,7 @@ homing_retract_dist: 0
 [tmc2209 stepper_x]
 uart_pin: PC1
 run_current: 0.860
-stealthchop_threshold: 180
+stealthchop_threshold: 0
 interpolate: False
 sense_resistor: 0.150
 uart_address: 3
@@ -60,7 +74,7 @@ homing_retract_dist: 0
 [tmc2209 stepper_y]
 uart_pin: PC0
 run_current: 0.900
-stealthchop_threshold: 180
+stealthchop_threshold: 0
 interpolate: False
 sense_resistor: 0.150
 uart_address: 3
@@ -81,7 +95,7 @@ homing_speed: 4
 [tmc2209 stepper_z]
 uart_pin: PA15
 run_current: 1.000
-stealthchop_threshold: 40
+stealthchop_threshold: 0
 interpolate: False
 sense_resistor: 0.150
 uart_address: 3
@@ -114,7 +128,7 @@ max_temp: 260
 [tmc2209 extruder]
 uart_pin: PC14
 run_current: 0.550
-stealthchop_threshold: 60
+stealthchop_threshold: 0
 interpolate: False
 sense_resistor: 0.150
 uart_address: 3
@@ -144,8 +158,8 @@ samples_tolerance_retries: 5
 
 [safe_z_home]
 home_xy_position: 85,135
-#z_hop: 10
-#z_hop_speed: 5
+z_hop: 10
+z_hop_speed: 5
 
 [bed_mesh]
 speed: 120