RP2040 adxl345 working. Input shaper values adjusted.

cfgs/adxl-rp2040.cfg

@@ -3,20 +3,23 @@
 #   https://www.klipper3d.org/Measuring_Resonances.html#adxl345
 #####################################################################
 
-[mcu rp2040]
+[mcu RP2040]
 baud: 115200 # 250000
 restart_method: command
 # Obtain definition by "ls -l /dev/serial/by-id/"
 serial: /dev/serial/by-id/usb-Klipper_rp2040_E66138935F154C28-if00
 
 [adxl345]
-spi_software_miso_pin: rp2040:gpio8
-cs_pin: rp2040:gpio9
-# spi_bus: spi0b
-spi_software_sclk_pin: rp2040:gpio10
-spi_software_mosi_pin: rp2040:gpio11
-axes_map: x,y,z
+axes_map: x,z,y   #  Installed with vertical ADXL  # For Diamond in X, y, z
+
+ # RP2040
+cs_pin: RP2040:gpio1 #RP2040:gpio1
+spi_bus: spi0a # spi0a  
 
 [resonance_tester]
 accel_chip: adxl345
-probe_points: 111.5, 111.5, 20
+probe_points: 111.5, 111.5, 20
+
+[gcode_macro ADX]
+gcode:
+    ACCELEROMETER_QUERY  # check ADXL345

printer.cfg

@@ -14,7 +14,7 @@
 [include ./cfgs/beeper.cfg]
 
 # NOTE Uncomment the ONE of the following lines if you're using an adxl345
-# [include ./cfgs/adxl-rp2040.cfg]
+[include ./cfgs/adxl-rp2040.cfg]
 # [include ./cfgs/adxl-direct.cfg]
 
 [mcu]
@@ -168,10 +168,10 @@ encoder_pins: ^PB14, ^PB10
 click_pin: ^!PB2
 
 [input_shaper]
-shaper_freq_x = 56.0
-shaper_type_x: mzv
-shaper_freq_y = 59.0
-shaper_type_y: 3hump_ei
+shaper_freq_x = 102.2
+shaper_type_x: 3hump_ei # mzv
+shaper_freq_y = 41.8 # 59.0
+shaper_type_y: mzv # 3hump_ei
 
 [bed_screws]
 screw1: 26.5, 31