Adjusted outline.

.vscode/settings.json

@@ -25,6 +25,7 @@
 		"PARKFRONT",
 		"PARKFRONTLOW",
 		"PARKREAR",
+		"pico",
 		"Prusa",
 		"runout",
 		"Sovol"

README.md

@@ -18,12 +18,12 @@ I am creating these files for my personal use and cannot be held responsible for
 - [Features](#features)
 - [Stay Up-to-Date](#stay-up-to-date)
 - [Preface](#preface)
-- [Installation Steps](#installation-steps)
 - [Before You Begin](#before-you-begin)
 - [Electronic Wiring](#electronic-wiring)
   - [⚠️ Important Note About Stepper Motor Current](#important-note-about-stepper-motor-current)
+- [Klipper Installation](#klipper-installation)
   - [Flash Firmware](#flash-firmware)
-  - [Download Klipper Configuration](#download-klipper-configuration)
+  - [Download OSS Klipper Configuration](#download-oss-klipper-configuration)
 - [Initial Steps](#initial-steps)
   1. [Adjust Configuration with MCU Path](#adjust-configuration-with-mcu-path)
   2. [Configure Your Printer](#configure-your-printer)
@@ -59,9 +59,7 @@ Watch for releases and updates.
 
 Although I've made switching over to Klipper as easy as is possible, it can still be a challenge for some, especially considering that most of you have likely never used GNU+Linux. Save yourself the frustration, and fully read all documentation found on this page. Also note that Klipper is not a _must_, and is not for everyone. You can stick with Marlin, and have a fine 3D printing experience.
 
-## Installation Steps
-
-### Before You Begin
+## Before You Begin
 
 - Read this documentation _fully!_
 - Make sure your printer is in good physical condition, because print and travel speeds will be _a lot faster_ than they were before. Consider yourself warned.
@@ -75,7 +73,7 @@ Although I've made switching over to Klipper as easy as is possible, it can stil
 - Your question has probably been answered already, but if it hasn't, please post in the [Discussion](https://github.com/bassamanator/Sovol-SV06-firmware/discussions) section.
 - I would recommend searching for the word `NOTE` in this repository. There are roughly half a dozen short points amongst the various files that you should be aware of if you're using this configuration.
 
-### Electronic Wiring
+## Electronic Wiring
 
 Wire cables according to the following diagram:
 <img src="./misc/skr-mini/skr-mini-e3-v3.0-v1678580296384.png" alt='skr-mini-e3-v3.0 installation instructions'/>
@@ -86,6 +84,8 @@ For the SKR-Mini-E3-V3.0, the `run_current` for x, y, z stepper motors has been
 
 💡 Although stepper motors can withstand upwards of 125C, they should at the most get hot to the touch (~55C), not _very hot_.
 
+## Klipper Installation
+
 ### Flash Firmware
 
 💡 _If you have already flashed klipper onto your motherboard in the past, you can skip this step._
@@ -123,7 +123,7 @@ Find instructions on how to build the firmware yourself [here](https://github.co
 5. Turn on the printer and wait a minute (usually takes 10 seconds).
 6. Turn off the printer and remove the microSD.
 
-### Download Klipper Configuration
+### Download OSS Klipper Configuration
 
 You can choose _either_ of the 2 following methods.