PublicArchives/Sovol-SV06-firmware
1
0
Fork 0
mirror of https://github.com/bassamanator/Sovol-SV06-firmware.git synced 2025-11-08 21:41:15 +00:00
Code Issues Packages Projects Releases Wiki Activity

Adjust FAQs.

Browse Source
This commit is contained in:
bassamanator
2024-01-14 21:30:33 -05:00
parent bd91fdef80
commit e416117048
1 changed files with 1 additions and 7 deletions
Download Patch File Download Diff File Expand all files Collapse all files

8
README.md
View File

@@ -72,7 +72,7 @@ In many ways, this entire repository can be considered _my opinion_ on the `3D p
## Before You Begin
- This entire page is a **13 minute read**. Save yourself _hours of troubleshooting_ and read this documentation fully.
- This entire page is a **12 minute read**. Save yourself _hours of troubleshooting_ and read this documentation fully.
- ⚠️ Make sure your printer is in good physical condition, because print and travel speeds will be _a lot faster_. Beginners would be wise to run through [these steps](https://github.com/bassamanator/everything-sovol-sv06/blob/main/initialsteps.md).
- [Disable](https://github.com/bassamanator/everything-sovol-sv06/blob/main/howto.md#disable-usb-cable-5v-pin) the USB cable's 5V pin.
- Follow the steps in order. If an error was reported at a step, do no proceed to the next step.
@@ -298,8 +298,6 @@ The printer will beep upon:
- Upon `PRINT_END`.
- `MECHANICAL_GANTRY_CALIBRATION`/`G34`.
Adjust behaviour according to your needs.
| File | `cfgs/misc-macros.cfg` |
| -------- | -------------------------- |
| Section | `[gcode_macro _globals]` |
@@ -311,8 +309,6 @@ Adjust behaviour according to your needs.
You can find information about the physical setup [here](https://github.com/bassamanator/everything-sovol-sv06#filament-sensor).
Adjust behaviour according to your needs.
| File | `cfgs/misc-macros.cfg` |
| -------- | ---------------------------------- |
| Section | `[gcode_macro _globals]` |
@@ -364,8 +360,6 @@ The printhead is now parked front center waiting for you to insert filament. You
This repo contains all the code from the KAMP repository, however, only the `adaptive meshing` and `LINE_PURGE` functionality of KAMP has been configured and tested for use. To enable other functionality, adjust `/cfgs/kamp/KAMP_Settings.cfg`.
Adjust behaviour according to your needs.
| File | `cfgs/misc-macros.cfg` |
| -------- | ------------------------ |
| Section | `[gcode_macro _globals]` |