diff --git a/cfgs/misc-macros.cfg b/cfgs/misc-macros.cfg
index 8eb32bc..8635f38 100644
--- a/cfgs/misc-macros.cfg
+++ b/cfgs/misc-macros.cfg
@@ -29,7 +29,7 @@ gcode:
 variable_filament_sensor_enabled: 1 # NOTE Enable(1) or disable(0) the filament sensor, if one is connected
 variable_beeping_enabled: 1 # NOTE Enable(1) or disable(0) beeping everywhere except during gantry calibration
 variable_bed_temp_over: 10 # NOTE Start print if bed temperature is over by this amount, otherwise wait for temperature drop
-variable_kamp_enable: 1 # NOTE Enable(1) or disable(0) KAMP (adaptive mesh)
+variable_kamp_enable: 0 # NOTE Enable(1) or disable(0) KAMP (adaptive mesh)
 variable_pre_purge_prime_length: 1.40
 gcode:
     # Don't delete this section
@@ -323,4 +323,4 @@ gcode:
         G4 P{dur}
         SET_PIN PIN=beeper VALUE=0
         G4 P{dur}
-    {% endfor %}
\ No newline at end of file
+    {% endfor %}
diff --git a/printer.cfg b/printer.cfg
index c1ea93b..06f8364 100644
--- a/printer.cfg
+++ b/printer.cfg
@@ -106,6 +106,7 @@ sensor_pin: PC5
 min_temp: 0
 max_temp: 300
 max_extrude_only_distance: 150.0
+max_extrude_cross_section: 5 # NOTE Uncomment this line if you intend on using KAMP purge
 pressure_advance: 0.0435 # 0.0465 # 0.044
 
 [tmc2209 extruder]