README.md contains full instructions. Added current SuperSlicer config bundle. printer.cfg adjusted: Z position_min, improved comments.

printer.cfg

@@ -37,7 +37,7 @@ microsteps: 32
 rotation_distance: 40
 endstop_pin: tmc2209_stepper_x:virtual_endstop
 position_endstop: 0
-position_max: 223
+position_max: 223 # NOTE You can adjust this if you have more room
 homing_speed: 40
 homing_retract_dist: 0
 
@@ -59,7 +59,7 @@ microsteps: 32
 rotation_distance: 40
 endstop_pin: tmc2209_stepper_y:virtual_endstop
 position_endstop: 0
-position_max: 223
+position_max: 223 # NOTE You can adjust this if you have more room
 homing_speed: 40
 homing_retract_dist: 0
 
@@ -80,8 +80,8 @@ enable_pin: !PC3
 microsteps: 32
 rotation_distance: 4
 endstop_pin: probe:z_virtual_endstop
-position_min: -3
-position_max: 258 # NOTE You may have to adjust this
+position_min: -4
+position_max: 258 # NOTE You can adjust this if you have more room
 homing_speed: 5
 
 [tmc2209 stepper_z]
@@ -104,6 +104,10 @@ filament_diameter: 1.750
 heater_pin: PA1
 sensor_type: EPCOS 100K B57560G104F
 sensor_pin: PC5
+control: pid
+pid_kd: 86.991
+pid_kp: 21.479
+pid_ki: 1.326
 min_temp: 0
 max_temp: 300
 max_extrude_only_distance: 150.0
@@ -121,6 +125,10 @@ uart_address: 3
 heater_pin: PA2
 sensor_type: EPCOS 100K B57560G104F
 sensor_pin: PC4
+control: pid
+pid_kp: 64.440
+pid_ki: 0.773
+pid_kd: 1343.571
 min_temp: 0
 max_temp: 110
 
@@ -138,7 +146,7 @@ samples_tolerance: 0.01
 samples_tolerance_retries: 5
 
 [safe_z_home]
-home_xy_position: 84.50, 135 # NOTE PROBE is at the center of the bed
+home_xy_position: 84.50, 135 # NOTE The probe is at the center of the bed.
 speed: 100.0
 z_hop: 10
 z_hop_speed: 15
@@ -201,19 +209,4 @@ screw_thread: CCW-M4
 [exclude_object]
 
 [force_move]
-enable_force_move: True
-
-#*# <---------------------- SAVE_CONFIG ---------------------->
-#*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
-#*#
-#*# [extruder]
-#*# control = pid
-#*# pid_kp = 21.047
-#*# pid_ki = 1.477
-#*# pid_kd = 74.981
-#*#
-#*# [heater_bed]
-#*# control = pid
-#*# pid_kp = 71.224
-#*# pid_ki = 1.341
-#*# pid_kd = 945.503
+enable_force_move: True