diff --git a/cfgs/misc-macros.cfg b/cfgs/misc-macros.cfg
index 6e0d4be..5ca1dc1 100644
--- a/cfgs/misc-macros.cfg
+++ b/cfgs/misc-macros.cfg
@@ -28,11 +28,13 @@ gcode:
 [gcode_macro _globals]
 variable_filament_sensor_enabled: 0 # NOTE Enable(1) or disable(0) the filament sensor, if one is connected
 variable_beeping_enabled: 1 # NOTE Enable(1) or disable(0) beeping everywhere except during gantry calibration
-variable_pre_purge_prime_length: 1.4
+variable_bed_temp_over: 10 # NOTE Start print if bed temperature is over by this amount, otherwise wait for temperature drop
+variable_pre_purge_prime_length: 1.40
 gcode:
     SET_GCODE_VARIABLE MACRO=_globals VARIABLE=pre_purge_prime_length VALUE={ variable_pre_purge_prime_length }
     SET_GCODE_VARIABLE MACRO=_globals VARIABLE=filament_sensor_enabled VALUE={ variable_filament_sensor_enabled }
     SET_GCODE_VARIABLE MACRO=_globals VARIABLE=beeping_enabled VALUE={ variable_beeping_enabled }
+    SET_GCODE_VARIABLE MACRO=_globals VARIABLE=bed_temp_over VALUE={ variable_bed_temp_over }
 
 [gcode_macro CONDITIONAL_BEEP]
 gcode:
@@ -129,7 +131,7 @@ gcode:
     
     # Other variables
     {% set bedtempSlicer = bedtemp %}
-    {% set bedtempRange = 10 %}
+    {% set bedtempOver = printer["gcode_macro _globals"].bed_temp_over|default(0)|int %}
     {% set maxVelocity = printer.configfile.settings.printer.max_velocity|default(200)|int %}
     {% set maxVelocityAdjusted =  (0.90 * maxVelocity * 60)|int %}
 
@@ -142,9 +144,9 @@ gcode:
     {% set hotendtempStepOne = ((hotendtemp, printer[printer.toolhead.extruder].temperature|int)|min, 150)|max %}
     {% set hotendtempStepTwo = ((hotendtemp, printer[printer.toolhead.extruder].temperature|int)|min, 170)|max %}
 
-    # If bed-temp-almost is higher than bed-temp by a maximum of 10C
+    # If bed-temp-almost is higher than bed-temp by a maximum of bed-temp-over
     {% if bedtempAlmost > bedtemp %}
-        {% if (bedtempAlmost - bedtempRange) <= bedtemp %}
+        {% if (bedtempAlmost - bedtempOver) <= bedtemp %}
             {% set bedtemp = bedtempAlmost %}
         {% endif %}
     {% endif %}