Merge branch 'temp-ms-good-mesh-edited' into personal

printer.cfg

@@ -44,7 +44,7 @@ homing_retract_dist: 0
 
 [tmc2209 stepper_x]
 uart_pin: PC1
-run_current: 0.860
+run_current: 1.000
 stealthchop_threshold: 0
 interpolate: False
 sense_resistor: 0.150
@@ -66,7 +66,7 @@ homing_retract_dist: 0
 
 [tmc2209 stepper_y]
 uart_pin: PC0
-run_current: 0.900
+run_current: 1.000
 stealthchop_threshold: 0
 interpolate: False
 sense_resistor: 0.150
@@ -245,7 +245,7 @@ runout_gcode:
 #*# pid_kd = 928.332
 #*#
 #*# [probe]
-#*# z_offset = 1.630
+#*# z_offset = 1.645
 #*#
 #*# [bed_mesh newbed]
 #*# version = 1
@@ -304,7 +304,7 @@ runout_gcode:
 #*# algo = bicubic
 #*# tension = 0.2
 #*#
-#*# [bed_mesh default]
+#*# [bed_mesh personalPreEdit]
 #*# version = 1
 #*# points =
 #*# 	  -0.147188, -0.085313, -0.033906, -0.025469, -0.035000
@@ -322,3 +322,22 @@ runout_gcode:
 #*# max_x = 222.0
 #*# min_y = 5.0
 #*# max_y = 203.0
+#*#
+#*# [bed_mesh default]
+#*# version = 1
+#*# points =
+#*# 	-0.068047, -0.070000, -0.055899, -0.055899, -0.063047
+#*# 	-0.075000, -0.112384, -0.090000, -0.087000, -0.100000
+#*# 	-0.123000, -0.112266, -0.110000, -0.100000, -0.100000
+#*# 	-0.121000, -0.105430, -0.110000, -0.110000, -0.100000
+#*# 	-0.120000, -0.071211, -0.091407, -0.080024, -0.080024
+#*# x_count = 5
+#*# y_count = 5
+#*# mesh_x_pps = 2
+#*# mesh_y_pps = 2
+#*# algo = bicubic
+#*# tension = 0.2
+#*# min_x = 27.0
+#*# max_x = 222.0
+#*# min_y = 5.0
+#*# max_y = 203.0