diff --git a/cfgs/misc-macros.cfg b/cfgs/misc-macros.cfg
index 007bf92..e987a76 100644
--- a/cfgs/misc-macros.cfg
+++ b/cfgs/misc-macros.cfg
@@ -136,8 +136,8 @@ gcode:
     {% endif %}
 
     {% set bedtempAlmost = (bedtemp - 2, 0)|max %}
-    {% set hotendtempStepOne = 150|int %}
-    {% set hotendtempStepTwo = 170|int %}
+    {% set hotendtempStepOne = ((hotendtemp, printer[printer.toolhead.extruder].temperature|int)|min, 150)|max %}
+    {% set hotendtempStepTwo = ((hotendtemp, printer[printer.toolhead.extruder].temperature|int)|min, 170)|max %}
 
     BED_MESH_PROFILE LOAD=default                                                ; NOTE if not using a mesh, comment out this line
     ADJUST_FILAMENT_SENSOR_STATUS ENABLE=1