diff --git a/README.md b/README.md
index 9b9030a..0c02986 100644
--- a/README.md
+++ b/README.md
@@ -78,6 +78,10 @@ Although I've made switching over to Klipper as easy as is possible, it can stil
 - It is assumed that you are connected to your host Raspberry Pi (or other host device) via SSH, and that your printer motherboard is connected to the host via a data USB cable. 💡 Most of the micro USB cables that you find at home are _unlikely_ to be data cables, and it's not possible to tell just by looking.
 - [Disable](https://github.com/bassamanator/everything-sovol-sv06/blob/main/howto.md#disable-usb-cable-5v-pin) the USB cable's 5V pin.
 - It is also assumed that the username on the host device is `pi`. If that is not the case, you will have to manually edit `moonraker.conf` and `cfgs/misc-macros.cfg` and change any mentions of `/home/pi` to `/home/yourUserName`.
+- Klipper _must_ be installed on the host Raspberry Pi for everything to work. Easiest is to use a [MainsailOS](https://github.com/mainsail-crew/mainsail/releases/latest) image. Alternatively, you can install `Fluidd` or `Mainsail` via [KIAUH](https://github.com/th33xitus/kiauh).
+- Klipper _must_ be up to date. Find updating instructions [here](https://github.com/bassamanator/Sovol-SV06-firmware/discussions/111).
+- Robert Redford's performance in _Spy Game (2001)_ was superb!
+- ~~It is assumed that there is one instance of Klipper installed. If you have multiple instances of Klipper installed, via `KIAUH` for example, then this guide is not for you. You can still use all the configs of course, but the steps in this guide will likely not work for you.~~
 - Your question has probably been answered already, but if it hasn't, please post in the [Discussion](https://github.com/bassamanator/Sovol-SV06-firmware/discussions) section.
 - I would recommend searching for the word `NOTE` in this repository. There are roughly half a dozen short points amongst the various files that you should be aware of if you're using this configuration.
 - You must have a `bed_mesh` for `PRINT_START` to work correctly. If you do not have probe to create a `bed_mesh`, simply comment out the line `BED_MESH_PROFILE LOAD=default` in the `PRINT_START` macro.
@@ -150,7 +154,7 @@ If the Klipper flash that you did earlier was successful, and you've done everyt
 
 💡 I recommend no filament be loaded for any of these steps.
 
-You will be pasting/typing these commands into the Mainsail/Fluidd console.
+🗒️ You will be pasting/typing these commands into the Mainsail/Fluidd console.
 
 1. Check to see if `X` and `Y` max positions can be reached, and adjust `position_max`, if necessary. I recommend leaving a 2mm gap for safety.
    1. `G28`