diff --git a/cfgs/misc-macros.cfg b/cfgs/misc-macros.cfg
index f8d952c..26e139a 100644
--- a/cfgs/misc-macros.cfg
+++ b/cfgs/misc-macros.cfg
@@ -32,6 +32,7 @@ variable_beeping_enabled: 0 # NOTE Enable(1) or disable(0) beeping everywhere ex
 variable_bed_temp_over: 10 # NOTE Start print if bed temperature is over by this amount, otherwise wait for temperature drop
 variable_pre_purge_prime_length: 1.40
 gcode:
+    # DELETEME This section is unnecessary
     SET_GCODE_VARIABLE MACRO=_globals VARIABLE=pre_purge_prime_length VALUE={ variable_pre_purge_prime_length }
     SET_GCODE_VARIABLE MACRO=_globals VARIABLE=filament_sensor_enabled VALUE={ variable_filament_sensor_enabled }
     SET_GCODE_VARIABLE MACRO=_globals VARIABLE=beeping_enabled VALUE={ variable_beeping_enabled }
@@ -88,10 +89,7 @@ gcode:
     {% set PRE_PURGE_PRIME_LENGTH=printer["gcode_macro _globals"].pre_purge_prime_length|default(1.40)|float %}
     ADJUST_FILAMENT_SENSOR_STATUS ENABLE=1
 
-    #   Get Boundaries
-    {% set max_x = printer.configfile.config["stepper_x"]["position_max"]|float %}
-    {% set max_y = printer.configfile.config["stepper_y"]["position_max"]|float %}
-    {% set max_z = printer.configfile.config["stepper_z"]["position_max"]|float %}
+    #   Misc variables
     {% set extrudeAmount = 26.6 %}
     {% set movementLength = 100.0 %}
     {% set movementSpeed = 15 * 60 %}
@@ -109,7 +107,7 @@ gcode:
     M83                                     ; Relative extrusion mode
     G1 E{PRE_PURGE_PRIME_LENGTH} F500       ; pre-purge prime LENGTH SHOULD MATCH YOUR PRINT_END RETRACT
     G1 X{xStart + movementLength} E{extrudeAmount} F{movementSpeed}       ; intro line 1
-    #G1 E-.5 F2100                                                                       # Retract
+
     G92 E0.0                                ; reset extruder
     M82                                     ; Absolute extrusion mode
     G1 Z5.0                                 ; move nozzle to prevent scratch