diff --git a/cfgs/misc-macros.cfg b/cfgs/misc-macros.cfg
index f30f81a..185da14 100644
--- a/cfgs/misc-macros.cfg
+++ b/cfgs/misc-macros.cfg
@@ -131,14 +131,17 @@ gcode:
     BED_MESH_PROFILE LOAD=default                                                ; NOTE if not using a mesh, comment out this line
     ADJUST_FILAMENT_SENSOR_STATUS ENABLE=1
 
-    G90
+    G90                                                                          ; absolute positioning
     M140 S{bedtempAlmost}                                                        ; set & don't wait for bed temp
     M104 S{hotendtempStepOne}                                                    ; set & don't wait for hotend temp
     G28 X Y
+    G1 X84.50 Y135 F{maxVelocityAdjusted}
 
     M190 S{bedtempAlmost}                                                        ; set & wait for bed temp
     M104 S{hotendtempStepTwo}                                                    ; set & don't wait for hotend temp
     M190 S{bedtemp}                                                              ; set & wait for bed temp
+
+    M104 S{hotendtemp}                                                           ; set & don't wait for hotend temp
     G28 Z                                                                        ; final z homing
 
     G1 X0 Y0 F{maxVelocityAdjusted}
@@ -149,7 +152,7 @@ gcode:
 [gcode_macro PRINT_END]
 gcode:
     ADJUST_FILAMENT_SENSOR_STATUS ENABLE=0
-    CONDITIONAL_BEEP I=2 DUR=30 FREQ=8500                               ; NOTE Comment out this line to stop the beeps at the end of a print
+    CONDITIONAL_BEEP I=2 DUR=30 FREQ=8500
     {% set PRE_PURGE_PRIME_LENGTH=printer["gcode_macro _globals"].pre_purge_prime_length|default(1.40)|float %}
 
     M400                                    ; wait for buffer to clear