diff --git a/README.md b/README.md
index 5d9f6d2..b29313e 100644
--- a/README.md
+++ b/README.md
@@ -338,11 +338,13 @@ Edit the relevant file according to your needs.
 | ---------------------- | ------------------------ |
 | `cfgs/misc-macros.cfg` | `[gcode_macro _globals]` |
 
-| Variable                           | Disable       | Enable        | Notes                                          |
-| ---------------------------------- | ------------- | ------------- | ---------------------------------------------- |
-| `variable_beeping_enabled`         | `0`           | `1` (default) |
-| `variable_filament_sensor_enabled` | `0` (default) | `1`           |
-| `variable_kamp_enable`             | `0` (default) | `1`           | See [here](#what-do-i-need-to-know-about-kamp) |
+| Variable                           | Disable       | Enable         | Notes                                          |
+| ---------------------------------- | ------------- | -------------- | ---------------------------------------------- |
+| `variable_beeping_enabled`         | `0`           | `1` (default)  |
+| `variable_filament_sensor_enabled` | `0` (default) | `1`            |
+| `variable_kamp_enable`             | `0` (default) | `1`            | See [here](#what-do-i-need-to-know-about-kamp) |
+| `variable_bed_temp_over`           | `0`           | `10` (default) | Speeds up print start                          |
+| `variable_bed_temp_not_exact`      | `0`           | `1` (default)  | Speeds up print start                          |
 
 ### How do I import a configuration bundle into SuperSlicer/PrusaSlicer?
 
diff --git a/cfgs/misc-macros.cfg b/cfgs/misc-macros.cfg
index 14e8f27..4265988 100644
--- a/cfgs/misc-macros.cfg
+++ b/cfgs/misc-macros.cfg
@@ -32,8 +32,8 @@ gcode:
 # NOTE 0 = false; 1 = true
 variable_filament_sensor_enabled: 0 # NOTE Enable(1) or disable(0) the filament sensor, if one is connected
 variable_beeping_enabled: 1 # NOTE Enable(1) or disable(0) beeping everywhere except during gantry calibration
-variable_bed_temp_over: 10 # NOTE Start print if bed temperature is over by this amount, otherwise wait for temperature drop
-variable_bed_temp_not_exact: 1 # NOTE Start print if bed temperature is `target temperature - 1` but continue to heat until target is reached
+variable_bed_temp_over: 10 # NOTE Start print if bed temperature is over by this amount. Set to 0 to disable, meaning, wait for temperature to drop
+variable_bed_temp_not_exact: 1 # NOTE Start print if bed temperature is `target temperature - 1` (but continue to heat until target is reached)
 variable_kamp_enable: 0 # NOTE Enable(1) or disable(0) KAMP (adaptive mesh)
 variable_pre_purge_prime_length: 1.40
 gcode: